Commercial Water Heater Maintenance Tips
It’s possible to save money by keeping your commercial water heater in good condition. It’s also a good way to maintain the safety of your employees. A commercial plumber can help you determine if your equipment is in need of repair. A commercial plumber can diagnose the problem, and help determine whether you should repair or replace your water heater.
A common warning sign of deterioration in your water heater is discolored water. Calcium deposits could cause discolored water. They can also block drain valves. A plumber can inspect your water heater to prevent it from going out of service.
Increased water consumption is another warning sign. If you notice more than the recommended amount of hot water is being produced, your heater is not working effectively. A loud sound may be heard. Typically, these signs indicate that the heater is nearing the end of its lifespan. If you have a tank type water heater, you will probably need to replace the entire unit.
If you suspect your water heater is leaking, you should turn off the electricity and gas. Attach a gardenhose to the drain valve. The hose should then be run to a good drainage spot. You may have to remove the hose from the blocked bibb.
You will first need to inspect the pressure and temperature relief valve before you can start. You will find the valve on either the side or top of your water heater. To remove the valve, you will need a wrench. It’s also a good idea to flush the water heater to get rid of sediment. You’ll need to follow the manufacturer’s instructions for this step.
If you have noticed that your water is rusty, brown, or orange, it could be an indication of a corroded heater. It is not normal and could lead to more serious problems. Rusted water heaters can cause reduced efficiency, which could lead to costly repairs. You will have to replace the damaged component if you find a tiny leak in your water heater.
Every three years, inspect your sacrificial rod. This is a critical part of your water heater. To prevent corrosion, it is important that you clean the anode hole. Bleach can be added to the anode opening if it’s dirty.
To prevent leakage, the temperature and pressure release valve (TPR) must be removed several times. If the valve isn’t drained, it can damage the heater or cause an explosion. It’s also a good idea for the valve to be replaced. You should attach a new valve with a discharge pipe and a pilot light.
If your water isn’t hot, it could be because the valve is clogged with calcium deposits. A rumbling sound can be caused by this. This could be an indication that your heater may have begun to fail.