Is Replacing Microbore Piping a Good Idea?

If you are looking to save money on your heating bills by installing a heat pump, then you might be wondering if replacing microbore piping is the way to go. Yes, it is possible to save thousands of dollars by installing a heat pump. But only if your budget allows for that. You will need to purchase a boiler or radiators as well as determine if the existing pipes can handle this additional load.

Microbore piping systems are two-pipe arrangements that deliver hot water to multiple radiators simultaneously. The typical system consists of 8mm and 10mm pipes as well as a water cooler, pressure relief valve and a water cooler. It is unique because there are less joints than traditional systems. As a result, the pipes are much easier to manipulate. The central heating system delivers hot water efficiently, providing a steady flow to many radiators. You will experience less cold spots, and more consistency in temperature throughout the areas you use most. It may be worth it to replace your central heating system with one of these, if you have the funds.

Microbore piping is a boon to southerners as it is not native to these regions. Although the idea of one loop of pipe isn’t new, modern underfloor systems offer significant efficiencies. The coil of piping beneath the floor is easier to use and safer, as well as being easy to install by one person. Having a single loop of piping can significantly cut down on the number of fittings and elbows you will need to install. It might also be the most cost effective way to run a ducting system.

The microbore piping system has been around for decades in Scandinavia. In fact, it has been used as far back as WW2 to connect the boiler to radiators. Its popularity has increased in recent years. The best way to make it work is to hire a qualified heating and plumbing contractor to do the job. For homeowners who are interested in green living, an underfloor piping system is a great money-saver. One loop of pipe can cut down on the amount of fittings required and reduce costs by up to 80%. In addition, the smaller diameter of the piping can mean lower maintenance costs and fewer leaks.

There are many advantages to replacing a microbore piping system, but it’s not as easy as you might think. If you have a lot of radiators, the cost for new fittings and pipework can quickly mount up. If you do decide to rip out the old and replace it with the new, be sure to do your homework and get a bid from a qualified heating engineer before you commit to the project.