Tips For Saddle Valve Installation
A saddle valve is a type of self piercing valve that is installed on your plumbing line. The installation of these valves is very simple and requires little or no technical skill. However, there are som
e things to keep in mind when installing a saddle valve.
First, make sure that your water line is free of debris and corrosion. Installing a pipe made of plastic requires that there be a compression sleeve placed on the tube. A brass compression nut is also recommended. The sleeve ensures that the valve seals tightly and reinforces the tubing wall.
The rubber gasket should be placed on the top of your tube. The rubber gasket protects the tube from any damage. You can clean the rubber gasket with a kitchen sponge or soap and water. If you notice any buildup, remove it with a cloth. If you notice any leaks, you should check the pipe for corrosion. If you find any corrosion, you will need to replace the valve.
Once the rubber gasket has been placed onto the pipe, it is time to install the valve. You can do this with a wrench, or a screwdriver. Mount the saddle valve over the rubber gasket. A cordless drill is a good option if you have a need for a hand tool. The drill should be plugged into a GFCI-protected outlet.
Before you start the saddle valve installation, you should turn off the main water valve. This will prevent water from spilling out during the installation process. The saddle valve should not be touched. This is because it can loosen the valve, leading to a leak. In some cases, this will also result in corrosion.
To install the valve, you should use a drill and a nut or a wrench. You should tighten the nut with no less than one or two turns. It is recommended that you have protective glasses on, especially when working with pipes. It will stop the drill bit falling apart.
Once you have the saddle valve and tubing inserted into the outlet, you should then clamp the end of the valve into place. You can then turn the water supply on to test the valve for leaks. If you find any leaks, you should fix the leak. If there are no leaks, you are ready to complete the valve installation.
After completing the saddle valve installation, you should be able to close your faucets. This will help relieve pressure and allow water to drain from the system. It is important to inspect the valve for any leaks. If you are unsure of the process, call a plumbing expert.
The saddle valve is a cost-effective and quick way to supply water to your house. They aren’t permitted in every area. If your area doesn’t permit saddle valves, you should consider other options. You might consider purchasing a plastic waterline instead. This can be easier to install, but it can also be harder to repair.