How to Do Your Own Tap Head Replacement

If you have noticed a slow flow from your tap or that your tap head isn’t spouting water, you may want to consider replacing it. If you do, you can do it yourself without having to call in a plumber. You can replace your tap with one that is newer depending on which model you have. You will have to first remove the head.

You will need a flat screwdriver to remove the head. Once this is in place, you can slide the cover off the spout. You will be able to then pull out the handle. To help you remove the aerator, you may use a flashlight.

Before you start removing the head, you’ll need to turn off the water at the mains. This should be done at least a few days before you start the job. If you can, it’s a good idea to wrap some cardboard around the spout. It will be easier to remove the grub screws that hold the head together.

It’s worth taking a close look at this valve. You can take off the shroud to check if the threaded portion is not nut-like. This indicates that the valve works. It is vital to understand this information, as you will need to ensure that the nut fits snugly and does not slip under the shroud.

The simplest way to replace the head is to unscrew the cap, which will reveal a single screw holding the handle to the head gear. You can then remove the whole unit if you like. If you’re not so handy with a screwdriver, you can also try using a basin wrench.

When comparing different replacement heads, you should be careful not to confuse the tap head with the handle. This is because you’ll need to use a different type of retaining screw. It’s also a good idea to check the gasket. You will need to replace the gasket if it is damaged or looks dirty.

You should also inspect the aerator. You should replace your aerator if you are able. Broken aerators can lead to a variety of issues. People may be even exposed to dangerous viruses in the water. If you have a stuck faucet, you should try various methods to fix it, such as soaking it in a bucket of water or using WD40.

You can also use a blowtorch to loosen build-up. This isn’t an easy task, though. If you have chrome-plated taps, you should avoid using a blowtorch as it could damage them. You can instead try a WD40 solution, which takes a little bit of time to work.

Finally, test the head. To ensure that the new head works, you should leave it on for at least 60 seconds. You will avoid any possible leaks.