Booster Pump Servicing London

What a booster pump service includes

A proper service is measurement, not a visual glance. We isolate and drain the water side of the accumulator to read the true pre-charge, reset it to the correct figure for the set pressure, clean the inlet strainer, test the non-return valves, and record cut-in and cut-out against the design set point. Each pump is run individually under load with its current measured and compared against the nameplate, and on twin sets we force a changeover to prove the standby pump actually starts and carries the duty.

• Accumulator pre-charge read on a drained water side
• Strainer cleaned, NRVs tested, leaks inspected
• Set pressures recorded against design
• Each pump run under load with current measured
• Duty/standby changeover and rotation proven
• Dry-run and low-level protection function tested

Why servicing prevents most breakdowns

Booster sets fail in slow motion. A vessel loses pre-charge over months, so the pump cycles harder and harder until the seal or the switch gives up during a peak. A standby pump that never runs corrodes on its shaft and will not start on the day the duty pump dies. A partially blocked strainer starves the pump and cooks the seal. None of these are dramatic in isolation, and all of them are picked up by a service that records numbers and compares them with last year.

• Cycling caught before it destroys a seal
• Standby pumps exercised so they start when needed
• Strainer blockage found before the pump runs dry
• Drifting controls corrected before pressure complaints start

Service intervals and contracts

A single domestic booster pump is normally serviced annually. Booster sets serving blocks, hotels, schools and commercial kitchens are better on a six-monthly cycle because the duty hours are far higher and the consequences of failure are worse. For multi-site portfolios we offer planned maintenance contracts with fixed visit pricing, an asset register for each pump, and priority response if a set fails between visits.

Records, compliance and reporting

Every visit produces a written record: pre-charge before and after, set pressures, running currents, changeover result, strainer condition and any defects found with a priced recommendation. Managing agents and facilities teams get the reporting they need for planned maintenance evidence, and you get a clear history that shows whether a pump is deteriorating or stable. Where a vessel or pump is at end of life we say so in the report rather than leaving it to fail.

• Photographed, dated service records
• Before and after pre-charge figures
• Defects listed with priced remedial options
• Asset register maintained across multi-pump sites